Categories
Contact Us

Add:99# Fenghuang South Road, On South Of Qingnian Road, Yancheng, Jiangsu, China
Contact:Nina.Young
Tel:+86-515-88693333, 88693588
Mobile:+86-15189219325
Fax:+86-515-88695188
E-mail:sales@cnabrasivegrinding.com

Web:www.cnabrasivegrinding.com

Service Hotline
+86-515-88693333

News

Home > NewsContent

The Use Of The Flap Disc In The Polishing And Deicing Industry

For the use of steel Flap Disc: these occasions on the rust of the working environment is poor, while the quality of the Flap Disc very high, in most cases, the equipment is supporting the large diameter of the wheels are thick, The intensity is higher. In high-speed rotating working environment, the wheels are required to have sufficient strength to prevent the wheel from bursting. Reinforcement is an important part of production. Because the quality of the Chiba belt itself is very light, even if the crack will not hurt the risk. Belt grinding is not as abrasive as the grinding wheel, especially dry grinding, grinding debris mainly composed of the workpiece is the processing of information, it is simple to recover and control dust. Polishing wheel is the higher the production efficiency requirements. Flap Disc Polishing waxes can reduce the cost of the product and meet the lead time. High-speed packaging machine requirements and the former process to have the relevant connection, without the need to transport links, including control of convergence, polishing wax the entire production line according to the production and packaging process to do reverse order, the order of downtime.

After the surface of the car after spraying, there may be coarse particles, sand marks, flow marks, anti-white, orange peel and other paint film surface defects, in order to make up for these defects, usually after spraying grinding and polishing to improve the film Mirror effect, to light, smooth, bright requirements. Here we come to understand the structure of the polishing machine and operational considerations.

Polishing machine from the base, selling, polishing fabric, polishing cover and cover and other basic components. The motor is fixed to the base, and the conical sleeve for the fixed disc is connected to the motor shaft by screws. The polished fabric is fastened to the polishing disc by the ferrule. After the motor is turned on by the switch on the base, the pressure is applied to the sample by hand to polish the rotating polishing disc. The polishing solution added during the polishing process can flow into the square plate placed next to the polishing machine through the drain pipe in the plastic tray fixed to the base. Drums and covers prevent dust and other debris from falling on the polished fabric when the machine is not in use.

The key to the operation of the polishing machine is to try to get the maximum polishing rate in order to remove the damage layer produced when polished as soon as possible. But also to make the polishing layer does not affect the final observation of the organization, that is, will not cause false tissue. The former requires the use of coarse abrasive to ensure a greater polishing rate to remove the polished damage layer, but the polishing layer is also deep; the latter requires the use of the finest material, so that the polishing layer is lighter, but polished Low rate. The best way to solve this contradiction is to divide the polishing into two stages. Rough cast is to remove the polished damage layer, this stage should have the largest polishing rate, the rough formation of the surface damage is a secondary consideration, but also should be as small as possible; followed by fine throw (or final throw) The purpose is to remove rough surface damage caused by roughing, so that polishing damage to a minimum.